Transducer Based Lift Station

Model LS-T2001 Specifications

• Standard Diplex Pump Control With Alternation
• Easy Interface To Existing Pump Control Panels
• Built In Pump Start Time Delays To Avoid Short Cycling
• Extensive Float Failure Alarm Analysis
• Dry Contract Output For Starter Fail Alarm
• High Level Alarm and Float Fail Alarm
• Station Will Still Pump Down With Float Failures
• 2 Amp, 240VAC Relay Capacity
• LED Indicators For System Operations
• Identification Of Float Activity
• Easily Removable Terminal Strip
• Designed for Operational Module OM-T2001

Model OM-T2001 Specifications

• Enhances Capability Of Duplex Controller LS-F2000
• Enhances Capability of Quadplex Controller WS-2001
• Accumulating Run Time Meters for Both Pumps
• Accumulating Cycle Time Meters for Both Pumps
• Visible Float Activity Indication
• Full Hand-Off-Auto Operator Selection
• Visible Pumping Status For Both Pumps
• Visible Float Failure Indication
• Visible High Level Alarm Indication
• Visible Starter Fail Indication
• Operator Resettable Run and Cycle Timers
• Bright Back Light For Visibility
• Powered By LS-T2001, No Separate Power Supply Required

Probe Housing

This Submersible device with 4-20 ma output is directly interfaced to U-Tap Control Panel LS-T2001. A high level float backup was also installed that immediately pumps down for an operator selected time while the station alarms out should an electronic failure occur.

Models available: 5PSI(11.5ft),10PSI(23 ft),15PSI(34 ft), and 20PSI(45 ft)
Operator Settings are from 0 To 100% of range